Age | Commit message (Collapse) | Author |
|
Signed-off-by: David P <megver83@parabola.nu>
|
|
This reverts commit fb2a4cae9a6d07a7fa69e6382f2ce11f6d6a8497.
|
|
This panel is present in the Nokia n900 smartphone. While this
smartphone is not officially supported by Parabola (it has a nonfree
bootloader on the device, and it also only has 256M of RAM so its use
is limited), this still enable users to make its display work if they
install Parabola on it.
Signed-off-by: Denis 'GNUtoo' Carikli <GNUtoo@cyberdimension.org>
|
|
Signed-off-by: David P <megver83@parabola.nu>
|
|
Signed-off-by: David P <megver83@parabola.nu>
|
|
Signed-off-by: David P <megver83@parabola.nu>
|
|
it broked the build
Signed-off-by: David P <megver83@parabola.nu>
|
|
Signed-off-by: David P <megver83@parabola.nu>
|
|
Signed-off-by: David P <megver83@parabola.nu>
|
|
The b43 and b43-legacy drivers were removed because their
corresponding upstream drivers loads a nonfree firmware.
However linux-libre-firmware has a free firmware
(ucode5.fw) that is used by both drivers.
The b43 and b43-legacy driver are also typically enabled
by Trisquel and Jason Self's linux-libre repository.
Note that some kernel parameters like qos=0 might be
necessary to make it work.
This regression was introduced in linux-libre by the
following commit:
32075365d upgpkg: libre/linux-libre 4.16.9_gnu-1
The drivers were added back by importing affected parts
from the following upstream kernels and configurations:
- config in linux-armv7 from Arch Linux ARM
- config.i686 in linux from Arch Linux 32
- config from linux from Arch Linux
Signed-off-by: Denis 'GNUtoo' Carikli <GNUtoo@cyberdimension.org>
|
|
The tg3 driver was removed because its upstream driver
loads a nonfree firmware. However with linux-libre, the
driver works fine without any nonfree firmware, at least
on some computers like the HP NC6320.
That driver is also typically enabled by Trisquel and
Jason Self's linux-libre repository.
This regression was introduced in linux-libre by the
following commit:
32075365d upgpkg: libre/linux-libre 4.16.9_gnu-1
The following configuration:
CONFIG_TIGON3=m
CONFIG_TIGON3_HWMON=y
is used in the following upstream kernels and
configurations:
- config in linux-armv7 from Arch Linux ARM
- config.i686 in linux from Arch Linux 32
- config from linux from Arch Linux
Signed-off-by: Denis 'GNUtoo' Carikli <GNUtoo@cyberdimension.org>
|
|
Signed-off-by: David P <megver83@parabola.nu>
|
|
Signed-off-by: David P <megver83@parabola.nu>
|
|
Signed-off-by: David P <megver83@parabola.nu>
|
|
Signed-off-by: David P <megver83@parabola.nu>
|
|
Signed-off-by: David P <megver83@parabola.nu>
|
|
Signed-off-by: David P <megver83@parabola.nu>
|
|
Signed-off-by: David P <megver83@parabola.nu>
|
|
Signed-off-by: David P <megver83@parabola.nu>
|
|
Signed-off-by: David P <megver83@parabola.nu>
|
|
Signed-off-by: David P <megver83@parabola.nu>
|
|
Signed-off-by: David P <megver83@parabola.nu>
|
|
Signed-off-by: David P <megver83@parabola.nu>
|
|
Signed-off-by: David P <megver83@parabola.nu>
|
|
this is the normal behaviour the kernels *must* have, because
that means that configs have to be updated
Signed-off-by: David P <megver83@parabola.nu>
|
|
Sometimes the defconfig and the source code are out of sync, this
can result in issues like this one:
| ==> Starting build()...
| scripts/kconfig/conf --syncconfig Kconfig
| *
| * Restart config...
| *
| *
| * General architecture-dependent options
| *
| OProfile system profiling (OPROFILE) [M/n/y/?] m
| OProfile multiplexing support (EXPERIMENTAL) (OPROFILE_EVENT_MULTIPLEX) [N/y/?] n
| Kprobes (KPROBES) [Y/n/?] y
| Optimize very unlikely/likely branches (JUMP_LABEL) [Y/n/?] y
| Static key selftest (STATIC_KEYS_SELFTEST) [N/y/?] n
| Stack Protector buffer overflow detection (STACKPROTECTOR) [Y/n/?] (NEW)
This makes sure that in such case, the default choice is used instead of
asking the user about it.
This feature has been requested by bill-auger as part of this bugreport:
https://labs.parabola.nu/issues/2319
Signed-off-by: Denis 'GNUtoo' Carikli <GNUtoo@cyberdimension.org>
|
|
Signed-off-by: David P <megver83@parabola.nu>
|
|
Signed-off-by: David P <megver83@parabola.nu>
|
|
Signed-off-by: David P <megver83@parabola.nu>
|
|
Signed-off-by: David P <megver83@parabola.nu>
|
|
Signed-off-by: David P <megver83@parabola.nu>
|
|
Signed-off-by: David P <megver83@parabola.nu>
|
|
Signed-off-by: David P <megver83@parabola.nu>
|
|
Signed-off-by: David P <megver83@parabola.nu>
|
|
Signed-off-by: David P <megver83@parabola.nu>
|
|
Signed-off-by: David P <megver83@parabola.nu>
|
|
Signed-off-by: David P <megver83@parabola.nu>
|
|
Signed-off-by: David P <megver83@parabola.nu>
|
|
and add ppc64le support (currently ppc64le packages at [libre-testing])
Signed-off-by: David P <megver83@parabola.nu>
|
|
Signed-off-by: David P <megver83@parabola.nu>
|
|
Signed-off-by: David P <megver83@parabola.nu>
|
|
Signed-off-by: David P <megver83@parabola.nu>
|
|
Signed-off-by: David P <megver83@parabola.nu>
|
|
Signed-off-by: David P <megver83@parabola.nu>
|
|
Signed-off-by: David P <megver83@parabola.nu>
|
|
Signed-off-by: David P <megver83@parabola.nu>
|
|
CONFIG_NFS_V4_1_IMPLEMENTATION_ID_DOMAIN="linux-libre.fsfla.org"
This was introduced in 4.17 by mistake
Signed-off-by: David P <megver83@parabola.nu>
|
|
Signed-off-by: David P <megver83@parabola.nu>
|
|
Signed-off-by: David P <megver83@parabola.nu>
|
|
Signed-off-by: David P <megver83@parabola.nu>
|